How To Install Roof Anchor

Roof Ballast Installation

When working on a roof the chance of falling is very high. The uneven surface combined with the pitch of the roof makes them one of the most high-take chances of a edifice to work on. Falling from the top of about roofs volition outcome in injury or expiry, and this is not acceptable. Roof ballast points are devices where workers on a roof can attach safety harnesses, ropes and other safe equipment used to arrest a fall in the case of an incident.

Roofs are covered in a range of materials. Terra cotta tiles, concrete tiles, slate, COLORBOND and other metal sheeting. Oft roofs are visible from the ground and class a vital visual entreatment in some buildings. Our roof anchors are designed to limit the visual impact and seamlessly integrate to existing roof structures.

Our anchor points allow for simple installation and small visual impact. They include a unique fall arrest energy arresting pattern. This effectively dissipates the energy of the fall and then that no jarring, whiplash or further damage is done to the person or property in the event of an incident.

How Roof Harness Ballast Points are Attached

The Australian Standards stipulate that for prophylactic roof access, roof anchor points demand to be installed within a certain spacing from both the point of access to the roof so between each ballast point. The same spacing applies to a roof access hatch. To attach an ballast point to an already existing roof there are 2 main methods, ane for metal roofs and the other for tiled roofs.

Metal Roofs - Anchor Point Installation

The metallic roof anchor point is installed past pre-drilling holes in line with the spacing of the ballast point and secure with industrial rivets the anchor point to the ridge of a corrugated sheet. These anchors are rated 1-human fall abort anchors - simply they could arrest the fall of up to 2 men per anchor. (15kN)

Tiled Roofs - Anchor Point Installation

For tiled roofs, a tile that sits over a rafter is removed and the ballast point is screwed into the rafter at the right height to allow the attachment point to beetle below the tile, fitting between the ii tiles. The tile is and so placed back into its original position. These anchors are rated 1 human fall arrest anchors - they could arrest the autumn of up to ii men per anchor.

On the left, an example of an anchor fitted to a Terracotta tiled roof. Observe that no holes are made in the tiles, preventing any leak issues.

Fitting is unobtrusive and does not detract from the artful appearance of the roof.

Have your building fitted with canonical anchor points to provide rubber to any workers accessing the roof, and prevent legal exposure - contact united states using the form to the right of this folio.

Source: https://www.sydneyanchorpoints.com.au/Anchor-Points/Roof-Anchor-Installation.htm

Posted by: mcleansualleadiang.blogspot.com

Share this post